• mononomi@feddit.nl
    link
    fedilink
    arrow-up
    5
    ·
    11 months ago

    Just thought about this, isn’t it a bit silly that we all use milli Ah while all the values are above the thousands? Like, 5000 mAh is just 5 Ah

    • ironhydroxide@sh.itjust.works
      link
      fedilink
      English
      arrow-up
      17
      arrow-down
      1
      ·
      edit-2
      11 months ago

      It’s because you can get more when measuring in mA than you can in A.

      5000 mAh means you can get 5000 hours out when pulling at 1mA. 5 Ah means you can get 5 hours when pulling at 1A.

      You’d think these are commutative, but battery chemistry doesn’t work that way. The harder you load, the less actual power you can get. So a battery that can provide 1mA for 5000 hours can’t necessarily provide 1A for 5 hours.

      • astrsk@kbin.social
        link
        fedilink
        arrow-up
        3
        ·
        11 months ago

        And not to mention the discharge efficiency curve. For LiPo batteries you will see a sort of “coasting” when the battery is at about 3.7v if your load is sufficiently small. But when it’s at 4.0v it will seem to drain quicker.

        I have a 10000mAh battery powering a device that uses 10uA every 30 minutes for about 10 seconds. On one charge it should last about 1 year maybe a little more. The first 2 months it seemed like it lost a lot more juice than was expected but since then it settled in and is now ahead of its estimate. Which means it will speed back up as it goes down below 3.7v.